EVERYTHING going wrong....

[lincpimp]

Your second list is correct.

All of the orange/white wires are signal, brown/black wires are ground, and red wires go in the center for 12v power.

If you servo is working correctly then you have it plugged in correctly, as the signal wires are closest to the center of the receiver case, and the black/brown wires are closest to the outside of the case.

Hope that makes sense.

Not sure what happened to the ubec, what brand is it?

it is the Castle UBEC. I was so upset when it started smoking!

it was like the devil did it!

Originally Posted by Andrew32

it is the Castle UBEC. I was so upset when it started smoking!

it was like the devil did it!

sounds like it may be possible when you wired in the UBEC tou reversed the polarity

Originally Posted by azjc

sounds like it may be possible when you wired in the UBEC tou reversed the polarity

i wish, that way i know waht happened.

but yea i def wired red to (+) and black to (-).

just looking at the UBEC and i realized the UBEC side has a signal wire, why would it ned a signal?

[MTBikerTim]

Originally Posted by Andrew32

just looking at the UBEC and i realized the UBEC side has a signal wire, why would it ned a signal?

It's used when programming via the PC. It's not needed I wouldn't think when being used normally.

ok guys thanks for all yalls input. Called CC toay adn they are taking care of me!