 |
|
|
|
 |
 |
 |
|
 |
|
(#5)
|
|
Guest
Posts: n/a
|
03.09.2008, 09:42 PM
No, i don't have mill, i must go on a machine shop to do the job, and it cost a lot of $$.
Just to make the hole3 for the 4 bearing, it cost me $96.00  The bearing for the top sliper shaft is 5x11 and those for the diff are 8x16. |
|
|
|
 |
 |
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Threaded Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
