What to do for a savage motor mount?

[lincpimp]

Originally Posted by MTBikerTim

What servo saver did it have on it and what saver have you changed too? I have been wanting to upgrade mine but haven't looked into it yet. Good to hear that it runs well and you really need to get some pics linc. No one really cares about the wiring.

It had a stock servo mounted saver. I replaced it with this: http://www3.towerhobbies.com/cgi-bin...?&I=LXJSS6&P=V

Night and day difference, much better. I will upgrade the servo too, and this kit comes with all of the different adapters to fit all of the servos.

[lincpimp]

Got my Hobby city order in a few days ago, with the hv becs!

Bought two of these: http://www.hobbycity.com/hobbycity/s...idProduct=6320

Wired one up to the savage and it works great, no interference, and it even has an on/off switch. It is not small, and has a ferrite ring (big one) mounted about halfway along the rec wire. That righ is almost as big as a ccbec, and the main part of the bec is easily twice as big as a ccbec!

Other updates to the truck are a new steering servo, hitec 5997tg, and i relocated the rec to the area in front of the servos. Also added the twin disk brake setup, HD center cvds, and rebuilt the front diff to a 4 spider design. Also added a rcm heatsink to the motor, and put a set of 17mm hexes and some pin style tires.

Still running the 2 4s 3600 packs, and they work fine. Bashed it hard today, and 20mins later had a 2wd truck! Something completely let go in the front diff.

It was a blast though, tons of power. I was jumping it off the side of a ditch that runs down the middle of my grassy bash area. Got at lest 6ft of air and the truck flew well on power. I will open up the front diff and have a look at it, may be time for some al diff cups! The hpi ss ones with the steel inserts look good, I will have to try them out!