Look what i did!

[MTBikerTim]

How did the wire get mangled?

[Mike_D]

I think when the motor pulled out it must have pull the black wire really hard, at least that's my best guess.

[Mike_D]

This is what i was doing.

[IMG][/IMG]

[MTBikerTim]

Originally Posted by Mike_D

I think when the motor pulled out it must have pull the black wire really hard, at least that's my best guess.

That makes sense. You should grab yourself one of the tekno motors.

[Mike_D]

Originally Posted by MTBikerTim

That makes sense. You should grab yourself one of the tekno motors.

Yeah that would be nice i hope they release them soon. If i do decide to go down the Neu route i would like one the Teknos just because the endbells are sealed, that's the one reason that i don't want to buy one of the standard ones. I may just get the Wanderer for now just to get back running and get the Tekno when it's available.

[_paralyzed_]

Would a kb45 fit the tekno mount? Tons of power for little money. Just needs a little modding.(6mm shaft, 4mm wider spaced mounting holes)

Originally Posted by MTBikerTim

How did the wire get mangled?

If the wires were under the roll bar, id say the spur ate it


Id go for a NEU!

[_paralyzed_]

I think that would be to much torque in a revo. and weight?

what does an XL bk45 weigh anyways?

470g for an L can and 600g for an XL. what is this, "too much torque" you speak of?

[legobrains]

If you did not mess up your windings, you could just use some JB weld, and put it back together.

But if you windings are damaged, I think your hosed.