MMM & DX3R Programming

[ilpufxit]

When I ran into the same problem programming a Quark, it turned out I had my throttle setting reversed on the tx.

Originally Posted by ilpufxit

When I ran into the same problem programming a Quark, it turned out I had my throttle setting reversed on the tx.

I set defaults 0n the radio before I began. I just tried reversing it though and same thing, it just can not find neutral.

The fan is getting broken in nicely. I think it is silly to run the fan during castle linking, but hey.

[Pdelcast]

Originally Posted by DickyT

I set defaults 0n the radio before I began. I just tried reversing it though and same thing, it just can not find neutral.

The fan is getting broken in nicely. I think it is silly to run the fan during castle linking, but hey.

Ah, the fan just runs all the time when there is power on the bus... it is silly, you are right. :)

I haven't heard of any issues with neutral programming -- can you put a servo on the throttle channel to make sure it isn't doing something weird? (make sure you have both forward and reverse (brake) throw, good center position, etc.)

Patrick