 |
|
|
|
 |
 |
 |
|
 |
|
(#7)
|
|
RC-Monster Admin
Offline
Posts: 14,609
Join Date: Nov 2005
Location: Des Moines, IA
|
05.20.2008, 12:58 PM
I have a Hyper8 and have no trouble with stripping gears at all. I think using two gaskets is definitely what caused them to strip - only the tops of the gears were meshed. Do what linc said: use gaskets that will properly shim the diff internals and use large shims on the outside bearings (between the CD mount and CD) to take up the slack. Only two or three should need to be used.
|
  |
|
 |
 |
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Threaded Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
