Brushless Kyosho S-RR

shark, nice job on the conversion.....lot of work. FYI....running the neu with the wires oriented on the low side will eventually result in pierced heat shrink on the wires where they smack the chassis and can short through the chassis intermittently.......

[Shark413]

cadima, thanks for the heads up, I'll keep an eye on the wires rubbing on the chassis. I was kind of worried about the wires where they exit the motor can, do they rub agains't the can and short out? I was thinking of putting a dab of silicone sealer around the holes to both seal the can and prevent the wires from rubbing.

[Shark413]

Here is part 2 of the video.

http://www.youtube.com/watch?v=QnwpWq7kynA