RC-Monster Forums  

Go Back   RC-Monster Forums > Support Forums > General Electric
Reload this Page Modded PC power supply for charging

 
 
Thread Tools Rating: Thread Rating: 2 votes, 5.00 average. Display Modes
Prev Previous Post   Next Post Next
Old
  (#20)
Topspeedtimmy
trick mad power (tmp)
 
Topspeedtimmy's Avatar
 
Offline
Posts: 102
Join Date: Nov 2007
Location: NE
07.07.2008, 01:19 PM
I have this old Antec 250w PS, but the voltage is 11.12v with no load and it goes below 11v when theres more than 15w load on the 12v wires. It's rated for 8A on the 12v rail. I don't want to spend any money on this piece of junk (especially since its only 96w), so is there any appropriate resistors I could take out of another circuit board from something else?

The timmy - Revo 3.3 MM 9XL 4s , Rustler MM 4600 3s
The ferty - Dual velineon Revo 3s, Rustler velineon 3s
   
Reply With Quote
 

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes Rate This Thread
Threaded Mode Threaded Mode
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Forum Jump







Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com

Contact Us - RC-Monster Store - Archive - Top