Aussie CRT X2

How did u mount the Tekno motor mount ffactory? I have an x1 i would like to have one of those on it.

Originally Posted by Fast5sRevo88

How did u mount the Tekno motor mount ffactory? I have an x1 i would like to have one of those on it.

You have to make 4 countersunk slots in the chassis for the mount and to allow gear mesh adjustment.

I just measured up drilled two holes ( make sure they are the right size for the screws ) were each slot starts and ends and then completed the slot with a dremel milling bit

Of course then i used a countersink bit . Dont forget though if using this mount you have to brace you centre diff somehow like i did .

Got a little present from Mike today

Needless to say i can now confirm for you guys that the CR buggy mount fits the X2
Just need to take the dremmel and put a notch in it were it sits on the center chassis brace for clearance .
You can see it in the pic .

Also Mikes mount is about 1mm taller than the stock diff mount so you just have to shim the top of the stock mount so the top diff plate sits square . Bearing carrier is spot on .

Now i have gotten rid of the centre diff braces i had to use on the Tekno mount, a lot cleaner looking

Also received my custom one piece battery trays , perfect .
They clear the diff nicely , sit on the mudguard spot on and best of all i can now use my Zippy packs along with the enerland cells .
After speaking to Jeff i also got the front wall of the tray machined thicker for those hard lawn dart accidents

[joeling]

ffactory666,

Originally Posted by ffactory666

Got a little present from Mike today

Needless to say i can now confirm for you guys that the CR buggy mount fits the X2
Just need to take the dremmel and put a notch in it were it sits on the center chassis brace for clearance .
You can see it in the pic .

Also Mikes mount is about 1mm taller than the stock diff mount so you just have to shim the top of the stock mount so the top diff plate sits square . Bearing carrier is spot on .

Now i have gotten rid of the centre diff braces i had to use on the Tekno mount, a lot cleaner looking

Also received my custom one piece battery trays , perfect .
They clear the diff nicely , sit on the mudguard spot on and best of all i can now use my Zippy packs along with the enerland cells .
After speaking to Jeff i also got the front wall of the tray machined thicker for those hard lawn dart accidents

U are doing good work here. Thanks for the pics & info. Invaluable.

Regards,
Joe Ling

Originally Posted by joeling

ffactory666,



U are doing good work here. Thanks for the pics & info. Invaluable.

Regards,
Joe Ling

No prob Joe , thats what these forums are for