Batch 2 V2 MMM

[blueb8llz]

my v1 almost died yesterday as well. i was bashing for 10 mins then needed to take a break because my 7xl as usual. 10 mins later, plugged everything in, turned the esc on, no beeps, no lights, but the fan was working. no signal to the remote either.
then i unplugged everything, and plugged everthing back in, mmm started working again.
wierd. it ran the entire lipo no problem afterwards.
i wonder why this happened.

[Nephre]

Originally Posted by blueb8llz

my v1 almost died yesterday as well. i was bashing for 10 mins then needed to take a break because my 7xl as usual. 10 mins later, plugged everything in, turned the esc on, no beeps, no lights, but the fan was working. no signal to the remote either.
then i unplugged everything, and plugged everthing back in, mmm started working again.
wierd. it ran the entire lipo no problem afterwards.
i wonder why this happened.

My MMM v2 acted the same way before it died. You had to disconnect and reconnect the battery a few times before it powered the rx. Then 3-4 minutes into the third pack it just shut down and have been dead since. It still works with the castle link but it just wont power up the rx or run the motor

[J3110]

Just outta curiosity, have you tried running a BEC or battery pack for the RX?

[Procharged5.0]

I received my long awaited V2 this morning! I can't wait to try it out!

Thanks again Mike!

[Nephre]

Originally Posted by J3110

Just outta curiosity, have you tried running a BEC or battery pack for the RX?

I haven´t, but a few other with the same problem have and it didn´t work

Sent mine in so I can´t try it either