How many MMM's work and how many dont?

[E-Revonut]

My v1 died after about an hour but I'm pretty sure it was my 8xl that killed it, not CC's fault but they replaced it with a v2 that I have about an hour on now with no problems since I got it working. Had a problem getting it to work at first because I had to update the firmware, since then no problems running with a 1515 2.5d Tekno Neu on 4s. Fan only comes on at startup, highest temp it has seen is 127* and that was running through tall/thick grass.

[e-mike]

e-revonut ...lucky you are

but for the v2 i think we ave more failure that the v1..!!???

[E-Revonut]

Originally Posted by e-mike

e-revonut ...lucky you are

but for the v2 i think we ave more failure that the v1..!!???

Although you may be right, not sure though, I think percentage wise they are doing better. If I remember correctly there was only 750 v1's released and they had about a 10% failure. I'm pretty sure that they have released many more v2's, at least 3 times that, so even if there was 150 failures, they're still ahead. Although I'm fairly new to the BL world I have learned alot in my short time here. I read alot of these threads. I beleive that I had read that they had similar failure rates with the MM. Now we have a near bulletproof esc that is getting pushed far beyond it's intended limits. I honestly beleive that everyone needs to be patient. We are really asking a lot of these controllers and of CC.

[wade7575]

I know when mine ded it died after ten minutes of running 4S in a 3905 E-MAXX and it was geared 18/68,it died and while I was at my Bashing spot I looked at the MMM and tried turning it off then on again it jumped about a foot or less,I took it home turned it on again and he same thing waited ten minutes or so it turned on again all the light's were flashing and it was wanting me to recailbrate it to the radio again so I did and it started the same thing all over again just jump's a foot then die's.The voltage from the BEC when I took a reading with my voltmeter was at .25 volt's.I think it could be another BEC problem were seeing but I'm no expert so I'm olny guessing,I was not using a CC/BEC with my MMM but did with my MM now I'm wishing I had,don't know if it would have made a difference though.On a lighter note here's a good MMM joke for you guy's.
How many idiot's does it take to find a reliable MMM in a mountain of MMM'S,give up,zero idiot's there is no such thing as a reliable MMM.
If you read my joke Patrick you gotta admit it's sort of funny,unless you read my joke just after your next profit meeting then you'll be laughing saying the next time that Bastard calls in saying his MMM is another dud tell him to get bent and we'll see who's laughing now.