Revo tranny center-diff opinions?

[neweuser]

Originally Posted by lincpimp

If they would design a new case that was similar to the new emaxx/erevo case, make it so that it uses the same input shaft and idler, but has the lower area remade to accept a diff. It would have larger bearing areas to accomodate 8/x16 bearings, and would have custom made output shafts. They would have to either make a 33t gear, or mod the existing gear like I will. The only real difference would be the larger bearings. I am stuck using 8x12 bearings as the stock tranny case has 6x12mm bearings stock.

I plan to use ceramic bearings, best that I can find.

Exactly my idea. I sent the idea to Mike yesterday, no response as of yet. I hope he thinks about it.

[lincpimp]

Originally Posted by neweuser

Exactly my idea. I sent the idea to Mike yesterday, no response as of yet. I hope he thinks about it.

We will see. I will continue my quest to get a decent diff in the stock tranny case...