Wiring

[standard_63]

The red plug/jumper is the programming jumper mentioned in Mike's writeup on how to program the 9920 controller, you should read it. It's a sticky in the BL forum.

The red wire is removed from the 3 pin plug to disable the internal BEC. There is also a black jumper behind that red one that will do the same thing.

Mike has the 3.5mm gold connectors for motor/esc you need, and the order doesn't really matter as long as the motor is turning in the right direction. If the motor turns reverse direction, you just swap the two outside wires and then it should turn the right way.
Hope that makes some sense!
--JD