Gear for Rustler??

[Raze ST Truggy]

Thanks for the replys guys.

I know I shouldn't be running the cc 5700 on 4S, but I do lots of stuff I'm not suposed to . Once I buy the medusa motor I'll be going with the 5mm shaft and upgrading to the revo/ jato spur slipper setup, and the FLM case.

For now I'm going to just play with what I have until I save up a little scratch or break something. As far as stripping spurs goes I too have that problem. I'm pretty sure that my mesh is good, but I know that I don't always check it after cartwheels across the parking lot. So maybe that plays a part. This time I also played with some of the settings on the mm to take out some start power.

I'll post up some results once I get it back on the street and a few runs past the radar gun.

-Brian