More New Stuff from IHobby

[What's_nitro?]

Originally Posted by TexasSP

I think these higher voltage servos are directed at airplane guys more than land.

Yeah the large scale planes could use them too, but here are the specs from JR-

Specs:

Size Category: Standard
Type: Digital
Application: 1/8, 1/5 on-road, off-road surface vehicles
Torque: 480 oz/in (2S Li-Po)
Speed: .12 sec/60°
Dimensions (WxLxH): .82" x 1.58" x 1.57"
Weight: 2.6 oz
Bushing Or Bearing: Bearing
Bearing: Dual
Motor Type: Coreless
Connector Type: JR
Gear Type: Metal
Gear Material: SuperSteel™
Voltage: 7.4V (2S Li-Po)
Deadband: Surface optimized

[BL_RV0]

Good. A servo that'll reliably run on 2s. I don't use Ni-MH packs for RX power, and I'm not totally satisfied with BEC's. I'm looking for a servo on steroids for my hyper ST or new project. This sounds pretty good.