mm + 4600 motor temp near 200 with rustler

Thats pretty good. Did you notice a difference in power or speed? Glad you got it worked out. I've been having major headaches with my stampede project. 2-3 months worth of sending speed controllers and motors back and forth. Just when I get it goin and it seems to be working right. I sheared the motor shaft clean off.

Based on my what I could tell the speed is very close to 13/90 with the 4600. Maybe the car is little faster with the vxl like the calculations should indicate but not much difference.

Oh well, temps were back up outside today amd I was able to get the vxl motor up to 200 degrees after a couple 15 minute non stop runs using the 19/90 combo. Will try a 16t to see how it does.