MMM V3 - First Run Opinions

[killajb]

I received my MMM last week and opened it up to inspect everything. I noticed that the edges of the circuit board are very sharp. As well, the receiver and fan leads had a nice slice through the insulation. I put shrink wrap around the receiver, fan and switch leads and also put shrink wrap around the female bullet connections. Otherwise, it's a very nice design.

[macr0w]

A couple of close shots of my modded MMMv3.

[e-mike]

Originally Posted by macr0w

A couple of close shots of my modded MMMv3.

do you use a ext. bec?????

Originally Posted by macr0w

A couple of close shots of my modded MMMv3.

Hey macr0w, have you drill a hole on each of the female bullets conectors on the MMM board to put the wires on and soldered them??

[macr0w]

Yeah, I drilled holes, tinned the wire good and stuck them in the holes and then feed a bunch of solder in there.

They seem to be good to go. It's got 2 weekends of hard racing and a few trips around the backyard and the street with no issues.

Like I said above it's "bone stock".

No external bec or anything.

[e-mike]

ta hate den avoir un mmmv3 hein mon david

en passent jarrive de rouler encore avec un v3 pi cer comme une ti vierge...ben ben lfun

[killermmn]

loool.david dont want a mmm!!!