Need help finding 17mm hexes to fit on crt.5!!! Integy (designed for traxxas)Dont fit

I believe a few of you guys have seen my truck. Its not done, but closer..

Basically the widening mod, is using LS10 parts, they all fit no problems right into the normal stuff, but are probably .3 in at least wider per side (dont have the truck in front of me now...) And are ALOT stronger

You can run the upper arms if you wish, just need some lunsford or something turnbuckles that are longer, I just went away with them (no pics of that yet)







Still need my turnbuckles, drive shafts, bearings, and all that stuff. But once I figure that out, I know I think it was hpi nitro mt2 17mm adaptor hubs made by new era fit. So bam, and done!

Any questions, just ask

[GO-RIDE.com]

Great idea BOR! In the past I bought the LS10 steering knuckles to try on the crt.5. They are a lot stronger looking, but the bearings were smaller than the crt.5 so I didn't get around to actually trying them. That's awesome that the LS10 arms fit straight on to the crt.5 hinge pins. They do look quite a bit stronger than the stock arms.

I just added a bunch of power to my RCM chassis crt.5 (MM, Medusa 3300, 3S) so I'd like to beef up the truck even more. Over the winter I'll have to keep my eye out for a used LS10.

Keep us up to date on how the truck comes along.