 |
|
|
|
 |
|
|
 |
 |
|
 |
|
(#1)
|
|
RC-Monster Dual Brushless
Offline
Posts: 4,236
Join Date: Dec 2007
Location: Cape Cod, Mass.
|
11.10.2008, 09:22 PM
I just used the disk it came w/ and the cc02 cable. I found that the small plug that goes into the esc itself is a pain in the a**. If it is not perfect, it will not work correctly. I have aslo had to check and recheck my connections to my cc02 cable...sometimes it will not work for no apparent reason.
2. MBX-5T 1520, MMM ON 5S 3. MBX-5 ONROAD CONVERSION 1515, MMM ON 5S 4. MRX-3 ON ROAD CONVERSION 1512, MMM ON 6S 5. TEN T 2650 T8, MMP ON 3S |
|
|
|
 |
 |
 |
|
|
|
|
|
|
(#2)
|
|
one.five.two.seven
Offline
Posts: 427
Join Date: Oct 2007
|
11.10.2008, 11:26 PM
OK, so now it will connect to the PC via the USBcom and CC02 cable. I'm trying to program the min/max throttle positions via the transmitter as per the manual. Trouble is, when i turn the Rx on while holding full throttle on the transmitter, i get no response from the ESC or Rx, so i cannot put the MGM into programming mode.
Anyone else had this problem before? I'm really stumped on this one 
|
|
|
|
|
|
|
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Hybrid Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
