Track time with the monster

Originally Posted by slimthelineman

sorry everyone, wasnt real specific earlier. its a v3 and yes it is the small rectangular componet between the coil and the edge of the pcb.

Ha Ha Ha I win...............

[BrianG]

Originally Posted by castlemike

Ha Ha Ha I win...............

That's only because you know what the V3 internals look like.

...And being an employee (engineer?) has nothing to do with it.

[Pdelcast]

Originally Posted by BrianG

That's only because you know what the V3 internals look like.

...And being an employee (engineer?) has nothing to do with it.

Yeah, Mike is our head Engineering Tech. No wonder..

[himalaya]

Originally Posted by Pdelcast

Yeah, Mike is our head Engineering Tech. No wonder..

Good, so who is your reflow soldering QC engineer? You should have a good talk to him.
I inspected two V2s and found A LOT of small solder balls ALL OVER THE PCB BOARD, some even locate between IC pins. The solder balls are held in place by either the solder resin or the protective film later applied on the board after soldering.

[bruce750i]

Originally Posted by himalaya

Good, so who is your reflow soldering QC engineer? You should have a good talk to him.
I inspected two V2s and found A LOT of small solder balls ALL OVER THE PCB BOARD, some even locate between IC pins. The solder balls are held in place by either the solder resin or the protective film later applied on the board after soldering.

ROFL, Welcome!