Castle connector ?

[Dagger Thrasher]

That's really weird...all of my 6.5mm connectors have a really tight fit. So tight, that I have a hard time pulling them apart lol, but they provide excellent contact. Perhaps Castle need to work on their tolerances a bit.

[rchippie]

Bernie at castle & mike at rc-monster said thats sinice im getting full contact & that they are fitting tight , not to worry about it . Just redo my heat shrink to cover the exposed area .

[Pdelcast]

Originally Posted by Dagger Thrasher

I just installed my castle 5.5mm connectors on my neu motor & castle esc & i noticed something. when put the two plug halfs together there is a small gap between the two ends . I pushed as hard as i could but they will not go on anymore . Has anyone else noticed this ?.

Probably there was a bit on one of the CNC turning centers that dulled -- and it didn't alarm until sometime after it built a few bad connectors -- and then they were missed by QC (just one thousandth of an inch in tolerance can cause the issue you described...)

I'd suggest you call tech support and just get them to send you an AWR. Tell 'em Patrick sent you.

[rchippie]

patrick this was acctually my comment . it's all good . I talked to bernie the other day . He said sinice im getting full contact that they are safe to use . but he is sending me another pair just to be sure . thank you for having great customer service. .