MMM V3 - Castle, I need some help - RC-Monster Forums

JesseV · 11.18.2008, 03:32 PM

I have a nice flash show if the switch is off, when i switch it on, theres the normal led flashing and then the neutral led lights. And green at throttle and red on brake/reverse. But when i switch back to off, it stays on (orange on neutral etc.:)

Works otherwise tho. And my wires look damaged too. But im gonna run it until it smokes, and i hope never. Takes too long to send from Finland and wait for a new one. Only if i HAVE to. I keep a bottle of freeze spray with me always while driving. :D

George16 · 11.18.2008, 06:06 PM

Quote:

Originally Posted by JesseV

Works otherwise tho. And my wires look damaged too. But im gonna run it until it smokes, and i hope never. Takes too long to send from Finland and wait for a new one. Only if i HAVE to. I keep a bottle of freeze spray with me always while driving. :D

Good thing it still works though. I have the same mentality. Run it until it quits and just send it in for castle to take care of it

.

e-mike · 11.18.2008, 06:39 PM

as i know its the death of the fifth mmmv3!!???so...the % is realy better than the mmmv2 or v1

BL_RV0 · 11.18.2008, 08:19 PM

Anyone notice how the MMM was run on 7s a123? I know it's rated for it, but since the nominal voltage is higher that 6s lipo, maybe the MMM had some kind of overvoltage failure.

e-mike · 11.18.2008, 09:00 PM

Quote:

Originally Posted by BL_RV0

Anyone notice how the MMM was run on 7s a123? I know it's rated for it, but since the nominal voltage is higher that 6s lipo, maybe the MMM had some kind of overvoltage failure.

could it be the failure

but what is the voltage of 7 123 cell at when they are fully charged???