Anyone notice the new clutch adaptors from Tekno! - RC-Monster Forums

Semi Pro · 02.06.2009, 04:01 PM

Quote:

Originally Posted by teknorc

One more question, how are the shoes installed?

If the two pins are 3 and 9 o'clock for example, is the 3 o'clock shoe on top or on bottom?

Your slipper seems like it's a little loose, although that shouldn't affect the clutch temp.

i have used them both leading and trailing with no affect on heat, right now my clutch is slipping alot more than the slipper, im only replaceing slipper pads and plates every 12-15 races.

i normaly have them installed leading as per tekno's instructions

the slipper is set to save the diffs and keep the wheels down when going to wot comeing out of a corner.

js058515 · 01:23 AM

Forgive the ignorance, but which direction are the shoes to be installed with the new 3 shoe adapter. Do they go on like the 2 shoe set up or the other way. I have a set of Kyosho aluminum shoes I want to try and test fit. Btw, I am using the Tekno V3 kit for the Losi 8B and 8T.

marzac2 · 02.07.2009, 01:36 AM

Quote:

Originally Posted by js058515

Forgive the ignorance, but which direction are the shoes to be installed with the new 3 shoe adapter. Do they go on like the 2 shoe set up or the other way. I have a set of Kyosho aluminum shoes I want to try and test fit. Btw, I am using the Tekno V3 kit for the Losi 8B and 8T.

Do you have the manual? Install them just as shown in the manual.

js058515 · 02.07.2009, 04:41 AM

Quote:

Originally Posted by marzac2

Do you have the manual? Install them just as shown in the manual.

I have the original manual 8T that shows the proper 2 shoe installation. Then it made sense after I realized the way the motor needs to spin in order for vehicle to go forward. So I installed them the same way. Thanks.