 |
|
|
|
 |
 |
 |
|
 |
|
(#8)
|
|
Guest
Posts: n/a
|
02.22.2009, 03:11 PM
My solution to strenghen main shafts, and to set 1/8 car torsen diff in the middle looks like this.
http://www.gfoto.com/UserPicPopup.as...B7A443#PicShow http://www.gfoto.com/UserPicPopup.as...B7A443#PicShow http://www.gfoto.com/UserPicPopup.as...B7A443#PicShow 1st Tamiya sleeves burned grease off, then drilling to allow cup screw take grip.( not genuine shaft, only for measuring) Shim plate to sheild bearing side , when STRONG threadlock takes hold on this bushing. This system allows use of 1/8 T-bones too. No matter where you install big cup as long as axle is 5mm and hole 8mm in cup. |
|
|
|
 |
 |
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Threaded Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
