Tekin 1/8 Scale controller release date?

[DwightSchrute]

Originally Posted by teamtekin

The Rx8 has a ton of user feedback with the 7 leds to show error codes and help diagnose issues. We show you if there is no radio signal, or we do not like the signal, or it is not changing like when a spectrum receiver will hand us the default neutral when it is not communicating with the transmitter.

speaking of spektrum, has there been any issues with compatability or calibration? I'm running the DX2, and sometimes other escs have arming issues without a programming card. could you speak to that at all?

[teamtekin]

Testing went very good although we had a lot of silly car issues. New car shakedown and all the typical stuff that someone forot to tighten.

We have not seen any issues with radios or binding. Many of the recievers do seem to need an additional cap. It is always best to keep the reciever wires away from the motor or battery wires for best range.

Turns out it was a 12 pole sensorless motor that we tested with to make sure we could keep up. We did, but it blew up in our Emaxx thrasher in the video on the web.

We are really happy with the 4pole design for sensored and sensorless operation. Everything really is working extremely well and I am very happy at this point.

[lutach]

Originally Posted by teamtekin

Turns out it was a 12 pole sensorless motor that we tested with to make sure we could keep up. We did, but it blew up in our Emaxx thrasher in the video on the web.

So it was a 12 pole outrunner then.