Hobbywing 80A on a e-crt.5

[BrianG]

I would be careful about using such a physically large ESC as it will sit rather high which is a potential danger zone should you land square on the lid. A MM with a UBEC if running over 2s would be ideal size-wise.

And I know you said you can't afford a Medusa, but honestly, they are about as good as you're gonna get for the price. Save up a couple/few weeks, you won't be disappointed. The cheap motors (Feigao and similar) are less efficient and you can really tell by the heat they produce.

Ideally, a MM with a Medusa 36-50-3300 running on 3s lipo with a UBEC would be the best bet IMO.

[hardmankam]

I have the hobbywing 150A (same size as 80A) currently installed in a 1/8. I also have a CRT.5.

Although I havent tried to install the 150A onto the CRT.5, but from my observations, the ESC is too BIG! This ESC is really designed to be used in 1/8 scale.

A good sized ESC for the CRT.5 would be the MM or 60A/120A hobbywing and run 2S or 3S.

[tkhoo]

Originally Posted by BrianG

I would be careful about using such a physically large ESC as it will sit rather high which is a potential danger zone should you land square on the lid. A MM with a UBEC if running over 2s would be ideal size-wise.

And I know you said you can't afford a Medusa, but honestly, they are about as good as you're gonna get for the price. Save up a couple/few weeks, you won't be disappointed. The cheap motors (Feigao and similar) are less efficient and you can really tell by the heat they produce.

Ideally, a MM with a Medusa 36-50-3300 running on 3s lipo with a UBEC would be the best bet IMO.

Hi, if I using 60A HW esc can this medusa will nicely pair up together with 3S? Medusa is 3 or 5mm shaft? Do you ship to Malaysia?

[superek4]

Originally Posted by tkhoo

Hi, if I using 60A HW esc can this medusa will nicely pair up together with 3S? Medusa is 3 or 5mm shaft? Do you ship to Malaysia?

bro, medusa is avail at Rc monster, impakrc. My 36x70mm 1600kv just came