 |
|
|
|
 |
|
|
 |
 |
|
 |
|
(#1)
|
|
RC-Monster Dual Brushless
Offline
Posts: 3,794
Join Date: May 2005
Location: georgia
|
03.11.2009, 06:43 PM
That's a nice build, I have been one of the quiet followers. I got a couple questions. Did you have to drill anything to get the towers on? or use stock holes? and , Have you considered using the hellfire arms on this beast?
People here hate Nitro, I love it. I start it, run it about 50 ft from me and it dies, I go after it. Perfect exercise |
|
|
|
 |
 |
 |
|
|
|
|
|
|
(#2)
|
|
Guest
Posts: n/a
|
03.11.2009, 09:08 PM
...thanks for the post Crazy :D
...I hadnt thought about the HF arm until you mentioned it but i will have a look at it...Sounds easy... ...one of the lower holes on the HF tower matches the tierod hole on the Savage bulk...I made the 3mm hole a 4mm hole and just put a bolt through... ...The UPPER pins protude a little bit which means this lower bolt that i put through needs about 4mm of spacers so the tower fits flush...Easier to see with pics that i will have to put up...Really very easy though once you see it :D ...Other than that i just drilled those two new holes in the tower to screw it to the bulkhead at the top...Check out the labelled pictures...You can see the 4x50 bolt i put in... |
|
|
|
|
|
|
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Hybrid Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
