Where does it work....

[MetalMan]

You could use it in your CRT if you convert over to the CR buggy mount and center bulkhead, otherwise you might not get the pinion to mesh with the spur. In fact, I am using the CR buggy center diff unit on my CRT.

[superek4]

Originally Posted by MetalMan

You could use it in your CRT if you convert over to the CR buggy mount and center bulkhead, otherwise you might not get the pinion to mesh with the spur. In fact, I am using the CR buggy center diff unit on my CRT.

So I must buy d cr center diff mount. Any other mod I need to do? So the slipper diff comes with 46 or 50t?

[superek4]

Originally Posted by MetalMan

You could use it in your CRT if you convert over to the CR buggy mount and center bulkhead, otherwise you might not get the pinion to mesh with the spur. In fact, I am using the CR buggy center diff unit on my CRT.

should I wait for mike to make the 62t diff?

[superek4]

Originally Posted by MetalMan

You could use it in your CRT if you convert over to the CR buggy mount and center bulkhead, otherwise you might not get the pinion to mesh with the spur. In fact, I am using the CR buggy center diff unit on my CRT.

hi, the CR center diff holder is shorter can I still use d CRT motor mount?

[MetalMan]

Originally Posted by superek4

hi, the CR center diff holder is shorter can I still use d CRT motor mount?

Unfortunately not, unless you do heavy modifications to the motor mount (but even then it still might not work).

[superek4]

Originally Posted by MetalMan

Unfortunately not, unless you do heavy modifications to the motor mount (but even then it still might not work).

so if I understood wat I m reading I can't use this diff with rc monster conversion?

Originally Posted by superek4

so if I understood wat I m reading I can't use this diff with rc monster conversion?

you can use this diff, i run a 11t pinion on my crt with a 46t spur, with the stock crt diff mount and motor mount, the spur only sits about a 1/4 inch off the chassis. its not a big deal

[superek4]

Originally Posted by big greg

you can use this diff, i run a 11t pinion on my crt with a 46t spur, with the stock crt diff mount and motor mount, the spur only sits about a 1/4 inch off the chassis. its not a big deal

thx, wats the speed r u getting? I m using a 1600kv n 2000kv medusa izzit
Ok with 4s n 6s.

Originally Posted by superek4

thx, wats the speed r u getting? I m using a 1600kv n 2000kv medusa izzit
Ok with 4s n 6s.

about 44 mph on 4s with a 1515 1y. you might wanna go with a 12 running the 2000 on 4s, for 6s i would gear it for the same speed and turn the epa down, its easier to switch voltages that way