Where does it work....

[RC-Monster Mike]

Originally Posted by brushlessboy16

hes not going to. Just use the SPeed calculator to compensate with your gearing.

This is correct - no plans to make a spur this large. I have a 50t spur in the works now. 46t and 50t will be it for a bit - these should cover most applications well enough with the appropriate pinions.

[jhautz]

It seems like everyone is asking will it work in this truck or this buggy. I'm not speaking for Mike here, but I think the truth is "theoretically" it should work in most 1/8 vehicles that use a converntional center diff. But I don't think its actually been installed in every vehicle on the market yet. That was the point of starting this thread. When you get one and install it, post up here with some pictures and some notes on what if anything you had to do to make it "fit" in your vehicle. There is bound to be some minor modification needed to make it fit in some vehicles and it will be a direct drop in for others. The intent of this thread was to start that database of what vehicles its been put into and what was needed to be done to make it work properly. An easy reference place for others to look.

People who have already ordered them or are ordering them soon will probably start getting them installed this week. Make sure you guys keep adding to this database of "Where does it work"

[superek4]

Originally Posted by RC-Monster Mike

This is correct - no plans to make a spur this large. I have a 50t spur in the works now. 46t and 50t will be it for a bit - these should cover most applications well enough with the appropriate pinions.

Hi Mike,

Need ur help here I m getting confused, it seems that I can't use this slipper diff in my converted CRT? I m ordering for a converted Losi8T too. So before I order now. Do u think it will work for these 2 cars?