jato to corr truck

[rootar]

3mm 6061 or 7075 t6 for the chassis

[whitrzac]

Originally Posted by rootar

3mm 6061 or 7075 t6 for the chassis

whats the diffrence between the 2??

[brushlessboy16]

Originally Posted by whitrzac

whats the diffrence between the 2??

7075 is a higher grade and stiffer IIRC

A Castle 2650 motor would work, along with a medusa 60 or 70.. Rx8 might be a bit overkill for this truck. and you dont need that much power because you will have a hard time putting it down through CORR tires.

[whitrzac]

Originally Posted by brushlessboy16

7075 is a higher grade and stiffer IIRC

A Castle 2650 motor would work, along with a medusa 60 or 70.. Rx8 might be a bit overkill for this truck. and you dont need that much power because you will have a hard time putting it down through CORR tires.

I just got back from the meeting, good news, its a run what ya brung class now


if anyone sees a novak 4.5/5.5HV for cheap, LMK

sooo, whats the best way to get power to the ground???

1/8 buggy tires, or ST tires?? Im thinking the sc10 wheels seem to be the right offset, after seeing one in person



just outof curiosity, between an sc10 with a 540 motor, and a E-jato...



the tekin is the esc that I'm geting as a replacement for my rs

[its me]

Ive experimented with jatos and to be honest I found the project not worth it, I either couldn't keep the trans together or I couldn't keep the tires glued...

I dont know if there's been recent improvements in then jato's trans but if there's not then I would say its not worth it.. The top shaft of the 2speed would always snap from the Rb 523