jato to corr truck

[whitrzac]

the 7075 plate should be here thurs or fri

I have a cupple unanswered questions...

any recommendations on a CHEAP motor for it?? I'm thinking a feigao just to get me by for awhile...(witch one???)

if not a feigao then will something like a CC 4600, or a novak 10.5(13mm rotor) be up to running this beast what I have...

whats the recommended wheel/tire?? 1/8 or 1/10?

what angle should I bend the sides of the chasis up? I know the more I go the stiffer it will get, but how stiff is too stiff...


since I'm making a custom motor mount, what distance should the motor shaft be from the top shaft on the tranny??


are there any slightly wider corr bodys that have the same wheelbase as the slash??

[whitrzac]

Originally Posted by whitrzac

the 7075 plate should be here thurs or fri

I have a cupple unanswered questions...

any recommendations on a CHEAP motor for it?? I'm thinking a feigao just to get me by for awhile...(witch one???)

if not a feigao then will something like a CC 4600, or a novak 10.5(13mm rotor) be up to running this beast what I have...

whats the recommended wheel/tire?? 1/8 or 1/10?

what angle should I bend the sides of the chassis up? I know the more I go the stiffer it will get, but how stiff is too stiff...


since I'm making a custom motor mount, what distance should the motor shaft be from the top shaft on the tranny??


are there any slightly wider corr bodys that have the same wheelbase as the slash??

anyone??

[halfcab]

the velineon traxxas motor should run quite a bit cooler and just begs for 3s to be a flyerand a velineon should be a bunch cheaper, around $40 on the bay usually when I have looked, my cc 5700 and my 4600 get pretty hot in my slash, the velineon in a freinds slash runs an easy 20-30 deg cooler, not sure if the gearing is lower in the jato or not but I would try the velineon over the cc motors for it