Trouble setting up the RX8 - RC-Monster Forums

TekinTeamMgr · 05.30.2009, 11:43 PM

DO NOT run the motor wired wrong. You MUST have a to a, b to b, and c to c.

You can do this ONLY if you are going to run a sensorless motor,period!

A radio calibration should not have caused a unit to fail. Contact support@teamtekin.com so we can take care of you.

magman · 05.31.2009, 08:22 AM

Quote:

Originally Posted by TekinTeamMgr

DO NOT run the motor wired wrong. You MUST have a to a, b to b, and c to c.

You can do this ONLY if you are going to run a sensorless motor,period!

A radio calibration should not have caused a unit to fail. Contact support@teamtekin.com so we can take care of you.

I did have the motor wired correctly....I triple checked before I plugged the batteries in.

I sent you guys an e-mail on Fri. night

Thanks

JThiessen · 05.31.2009, 10:50 AM

Quote:

Originally Posted by magman

I did have the motor wired correctly....I triple checked before I plugged the batteries in.

I sent you guys an e-mail on Fri. night

Thanks

I think he was referring to the "help" suggestion from Himalya