medusa motors?

Originally Posted by Arct1k

3s 50mm 3300 Medusa with 1/8" shaft

+1

I use this motor in my Rustler...it rocks on 3s...but when you bump it to 4s...it is 800W of punch...and the motor stays around ~130 degrees.

[rcsammy]

Originally Posted by fletchoman

+1

I use this motor in my Rustler...it rocks on 3s...but when you bump it to 4s...it is 800W of punch...and the motor stays around ~130 degrees.

i was set on getting the 2200 till i saw your post lol
what gearing are you running? and whats speed/power like?
at the moment im running 3S but would like to go up to 4S at somepoint so would be nice to know the motors going to run it fine

Originally Posted by rcsammy

i was set on getting the 2200 till i saw your post lol
what gearing are you running? and whats speed/power like?
at the moment im running 3S but would like to go up to 4S at somepoint so would be nice to know the motors going to run it fine

I am using 19/90 now but the motor is very efficient which allows lots of flexibility...I recommend gearing for ~40 given that the Rustler isn't always the best handling vehicle.

Tease: http://www.youtube.com/watch?v=1ekpJmWMys4