Lipo repair

[lincpimp]

Originally Posted by gimpygolden

Hey Linc, If you haven't put the Deans on the A123's can you add a short lead of 18Gauge or similar to the main leads. One on pos one on neg.

I want to use them for a "No Spark" setup. If you've already done the connectors or don't have any small gauge wire don't worry about it.
Hey you could even use some cut offs from balance leads if you have any.

I'm sure you know what I'm goin for but if not
http://www.scriptasylum.com/rc_speed/_nospark.html click on diagram for Deans.

Thanks man

I can do that, I do not have any small connectors to put on the wires, but I am sure that you can do that.

[gimpygolden]

Originally Posted by lincpimp

I can do that, I do not have any small connectors to put on the wires, but I am sure that you can do that.

Cool thanks. I have some mini Deans sitting here I'm going to use.
thanks

[gimpygolden]

It's a Turnigy 80Hv Marine esc. It already has the lead with a resistor for a "No Spark" just need to do connectors on the pack side. If I were using Bullets the additional leads wouldn't be needed.