Rustler VXL Trailer - RC-Monster Forums

suicideneil · 07.30.2009, 02:53 PM

Its around the 375 second mark- but that is a fairly isolated incident. It does drop down around 9v with most 50amp bursts, but thats the thing- it isnt consistent. One 70amps burst drops it down to 9.7v, another a few minutes later drags it down much lower...

I would like to see a couple of these pacsk in parallel, that would boulster the performance for sure.

skellyo · 07.30.2009, 03:44 PM

Quote:

Originally Posted by suicideneil

Its around the 375 second mark- but that is a fairly isolated incident. It does drop down around 9v with most 50amp bursts, but thats the thing- it isnt consistent. One 70amps burst drops it down to 9.7v, another a few minutes later drags it down much lower...

I would like to see a couple of these pacsk in parallel, that would boulster the performance for sure.

Oh, no doubt. I'd bet that if the capacity of this pack was doubled, the voltage would be maintained to 3.5V+/cell for just about any peaks.

07.31.2009, 06:42 AM

Quote:

Originally Posted by skellyo

Oh, no doubt. I'd bet that if the capacity of this pack was doubled, the voltage would be maintained to 3.5V+/cell for just about any peaks.

Well, I got 2 of those packs. I use them both in the Rustler VXL so they have about the same cycles. Maybe I should try it once and log it?

skellyo · 07.31.2009, 10:12 AM

Quote:

Originally Posted by Byte

Well, I got 2 of those packs. I use them both in the Rustler VXL so they have about the same cycles. Maybe I should try it once and log it?

If you've got the time and don't mind, it would be a great reference point. Also, can you plot the voltage and current on the same graph for it?