RC-Monster Forums  

Go Back   RC-Monster Forums > Support Forums > HPI Savage

 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old
  (#8)
scarletboa
RC-Monster Aluminum
 
scarletboa's Avatar
 
Offline
Posts: 929
Join Date: Mar 2009
Location: Las Vegas NV
09.04.2009, 09:08 PM

those chargers have a 3 month or 1 yr warranty. i have the $35 version and it has worked very well for me. the only downside of getting a warranty replacement is sending the defective one in. shipping to hong kong is a little pricey.

that charger is supposed to have the same "brains" as mine and mine is dead accurate. 4.20 is the usual cutoff per cell. occasionally it'll only go to 4.19, but that is good enough unless you have severe OCD.

edit: i have that 2x3s adaptor, but only because i run 2 3s packs in my BL converted savage. if you do end up ordering from hc again, you should pick up 2 of these
http://www.hobbycity.com/hobbycity/s..._20C_Lipo_Pack

those packs are only 20c, so if i were you, i would use the 18t pinion for 6s. some people say those packs are underrated and are actually 25c packs. for $30 each, you can't go wrong.


They say a good mechanic only needs 2 tools - WD40 & Duct tape. If it moves, and its not supposed to, duct tape. If it doesn't move, and its supposed to, WD40.

Last edited by scarletboa; 09.04.2009 at 09:16 PM.
   
Reply With Quote
 


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump







Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com