 |
|
|
|
 |
 |
 |
|
 |
|
(#18)
|
|
RC-Monster Aluminum
Offline
Posts: 972
Join Date: Feb 2008
|
01.24.2010, 03:08 AM
I can't say for sure if it was a rcm pinion, but I can't fault it. I kind of neglected to dry and wd40 it after driving it in wet, salty and ice melt chems. Check out the set screw it was a small bolt hanging out too far. It rusted and broke off futher complicating the matter. Also I had a somewhat high motor rpm setup on 6s adding to the friction.
|
|
|
|
 |
 |
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Threaded Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
