Scorpion motors??

[jzemaxx]

Originally Posted by sikeston34m

Check the outside dimensions.

The 30xx line of motors have a 25mm mounting pattern using m3 screws.

I believe the 40xx line has a 30mm mounting pattern using m4 screws.

I have used outrunner motors with alot of success.

As far as eff% lets say in truggy with one of these motors.....how would it do. I'm new to the outrunner world. Are they more torquey or more eff% then say a NEU 1515? I was hoping to move to a 6S setup that would make good power and long runtimes to run these new 60min mains the Nitro's are doing. How does length effect the motor? I see they are a good bit shorter then a NEU even though the diameter is the same or close.