 |
|
|
|
 |
 |
 |
|
 |
|
(#23)
|
|
Soldermaster Extraordinaire
Offline
Posts: 4,529
Join Date: Apr 2007
Location: Plymouth, MA, USA
|
05.16.2010, 07:29 PM
Yeah bearings need to be fitted very precisely to avoid abnormal wear.
Is $12 better? http://cgi.ebay.com/16mm-Drill-Bit-/...item1c127fb267 Or see if this guy will accept $10? http://cgi.ebay.com/National-Twist-D...item2557529352 Now that I think about it though, if you drill them by hand chances are the hole will be a bit bigger than the bit since your arm cannot mimic a drill press. That 1/8mm might not matter in the end... |
|
|
|
 |
 |
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Threaded Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
