Mounting a MMPro in 3905 help

[sikeston34m]

Originally Posted by notnodak

I just got my MMPro in the mail today and will be mounting it in a 3905. The MM it's replacing is held by the two factory ESC screws and it works perfect but the Pro might be a different case size so..... What is the CLEANEST way to mount a MMPro in a 3905?

I'll tell you what I did.

Get a MMM Mount, then use velcro underneath it also.

The MM Pro is just a little shorter than the MMM, so the velcro aids in holding it, plus helps take up that little bit of extra space.

Plus you have a place to mount the ON/OFF switch.

[notnodak]

Originally Posted by sikeston34m

I'll tell you what I did.

Get a MMM Mount, then use velcro underneath it also.

The MM Pro is just a little shorter than the MMM, so the velcro aids in holding it, plus helps take up that little bit of extra space.

Plus you have a place to mount the ON/OFF switch.

Thanks for the hint. Gotta pic?

The Pro should work great. I'm using a MM now with a 2600xl Hobbycity motor and it's fine. I do use a UBEC with it but the New stuff in the Pro will handle it all like a pro. I will be going to a Castle 2650 motor also which will be even better. As far as the two servos I'm guessing it'll be a load but with the tunability it'll work fine.

[sikeston34m]

Originally Posted by notnodak

Thanks for the hint. Gotta pic?

The Pro should work great. I'm using a MM now with a 2600xl Hobbycity motor and it's fine. I do use a UBEC with it but the New stuff in the Pro will handle it all like a pro. I will be going to a Castle 2650 motor also which will be even better. As far as the two servos I'm guessing it'll be a load but with the tunability it'll work fine.

Yes, I do.

This is an E Revo, but will work the same for your E maxx.