Talk 1520 - your experiences

[Jahay]

that is a beautiful home made cd motor mount!!! You have a very nice truggy there!!!
You can see no expense has been spared!

Do you think you would like to make me one of those cd mounts :)

[ANGRY-ALIEN]

Thanks man... some expense was spared with homemade parts ... i'm not sure if I'll ever want to know how much money went into this build over the years...
hmmm... regarding the mount... it was a one off thing (materials here are scarce and I have to import almost everything i need)... So I'm not sure how feasible it would
be to make a small run on this design... besides, I wouldn't want to disrespect the site owner by peddling my stuff here...

Thanks again for the compliments dude.


Alien

[nuz69]

Update for me :



14/46 ===> 17/46
The same deal for the motor, sames temps as 14/46 and insaaaaaaane top speed Moreover wheelies are easier as in 14/46 (didn't touch the 70% punch control !).
But a bad thing happened... I did one time a full throttle from 0 speed, and my truggy responded by a DOUBLE standing backflip !! "OMG, WTF this 1520 is doing to my truggy :D :D !!!" ====> my out-shaft of center diff melted in the spur, blocked the diff... mugen parts are precise engineered, and the shaft enter tiely in the spur :( metal vs metal = heat, i didn't have this problem with the 14/46, but in 17/46 diff works maybe a lot more... I tried to enlarge a little the spur hole, but mugen parts are very heavy too ^^ Will see tomorrow if it works better.
anyway, this motor can handle bigger pinions and keep exactly the same temps, impressive

[ANGRY-ALIEN]

Powerrr!!! ... are you going to make some vids with that 17 tooth setup? can't wait to see that.

[nuz69]

Originally Posted by ANGRY-ALIEN

Powerrr!!! ... are you going to make some vids with that 17 tooth setup? can't wait to see that.

Coming today :D