 |
|
|
|
 |
|
|
 |
 |
|
 |
|
(#1)
|
|
RC-Monster Dual Brushless
Offline
Posts: 4,236
Join Date: Dec 2007
Location: Cape Cod, Mass.
|
06.01.2010, 04:04 PM
I do not think it will fit w/out some serious shimming. My 1520 required some shimming and the 1717 is quite a bit bigger diameter can than the 1520 i believe
2. MBX-5T 1520, MMM ON 5S 3. MBX-5 ONROAD CONVERSION 1515, MMM ON 5S 4. MRX-3 ON ROAD CONVERSION 1512, MMM ON 6S 5. TEN T 2650 T8, MMP ON 3S |
|
|
|
 |
 |
 |
|
|
|
|
|
|
(#2)
|
|
RC-Monster Carbon Fiber
Offline
Posts: 209
Join Date: Sep 2008
|
06.01.2010, 04:10 PM
Did you use the RCM mount with your 1520?
|
|
|
|
|
|
|
|
|
|
|
|
|
(#3)
|
|
|
RC-Monster Dual Brushless
Offline
Posts: 4,236
Join Date: Dec 2007
Location: Cape Cod, Mass.
|
06.01.2010, 06:16 PM
Quote:
 I used 4 small flat washers..2-3mm thick to prop up the center diff a bit which gave the motor about 5-7mm of clearance on the chassis..Have had no issues w/it at all.
2. MBX-5T 1520, MMM ON 5S 3. MBX-5 ONROAD CONVERSION 1515, MMM ON 5S 4. MRX-3 ON ROAD CONVERSION 1512, MMM ON 6S 5. TEN T 2650 T8, MMP ON 3S |
|
|
|
|
|
|
|
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Hybrid Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
