The low budget DIY XL conversion

[Nixpus]

Some progres:

Motor mount ala Lincpimp:


Its 2mm HD steel... I couldn't bend anything thicker. In order to avoid damaging the thread I made in the steel sheet I'll add some M4 screws on top of it. Actually I could just have made some straight holes and added the screws after...

Yes it can wobble a little... a little :) I'll have to add some sort of support in the rear. However it can only wobble vertically. Not horizontally... so it should be pretty easy to fix.

Drilled a hole in the bend line to get the motor as low as possible:


I can mesh 13-19 tooth pinions as it is:


Chassis with battery trays:


Tested it a little around the parking lot with the KB on 3 cells. looked good :)