 |
|
|
|
 |
 |
 |
|
 |
|
(#4)
|
|
Fat Kid Engineering
Offline
Posts: 3,634
Join Date: Jun 2009
Location: Hot as Hell West Central Coast Florida
|
07.25.2010, 01:18 PM
With it being a Little TC and space being in short supply I decided to shorten all the wires.
It takes guts to open and solder wires on a new $80.00 servo. One thing I noticed that I didn't like with this Spektrum Servo is that were the wires are soldered to the board is more inside the servo instead of being more accesable like the JR's. So rather than desoldering the wires form the board I chose to cut then instead. Not as neat as I would have liked but it suites the purpose.    I decided to mount the RX on top of the servo and made a antenna mount.   Shortened wire for the MMPro also.  100% complete chassis 
|
|
|
|
 |
 |
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Threaded Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
