Freeze's Savage Flux "Frostbyte II" build thread

[Muggydude]

I plan on sealing my motor the sme way, but there is some stock on dirt in the holes, and I don't think blowing them intot the motor witha compressor is such a good I dea. How should i clean it?

Part 7: Suspension arm upgrade and mods


I learned my first lesson quickly with my first Flux: "Stock A arms do not last long" With that, after suffering major front end damage on my original A arm's, I immedietely switched to RPM arms. However, like everything else in life, there was a tradeoff. RPM's fit and finish with their products tends to be "hit and miss". That being said, I had to do some major dremling in order for the RPM arms to swing freely on my first Flux. And the second time around unfortunately, was going to be no exception





Not much to say this time around except I spent SEVERAL hours dremeling out my new, blue RPM arms in order for them to swing properly without binding. What a farking pain......









The upper arms required the most work. I had to bore out the hinge pins holes majorly to get them to swing freely. Thanks alot for the quality control RPM...






One arm down, three more to go. Ung......