Lipo repair

[Jahay]

i have taken the heat shrink off but i have wires coming out at either end... here are some pictures close up of either side. If you can spot something that i am completely missing, then please let me know and advice on how to sort the problem...

Thanks



In the picture below... is this metal part meant to be sticking out??? or should it be tucked in somewhere like the rest?







I hope these pictures help... As you can see there are positive and negative wires at either end and balance leeds connecting... i cannot see any cracks in the solder or obvious breaks. Is the flap that seems to be sticking out possibly the problem??

Thank you

Josh

[brushlessboy16]

Originally Posted by Jahay

I hope these pictures help... As you can see there are positive and negative wires at either end and balance leeds connecting... i cannot see any cracks in the solder or obvious breaks. Is the flap that seems to be sticking out possibly the problem??

Thank you

Josh

THat picture, left side, looks like a crack in the solder, hard to tell. Reflow those puppies- they look ghettooo(means alot coming from a black guy)


that metal peice is where the cell's aluminum tab is attached to the copper tab for soldering

Tuck it up out of the way