1/6th Scale Savage Conversion - RC-Monster Forums

		RC-Monster Forums > Support Forums > HPI Savage
1/6th Scale Savage Conversion

Thread Rating: 12 votes, 5.00 average.

Prev

Previous Post

Next Post

Next

	(#28)
Finnster KillaHurtz Offline Posts: 2,958 Join Date: Apr 2006 Location: Bucks Co, PA	11.17.2010, 12:25 PM Did the finishing work on this bulkhead before I went to bed last night. Turns out well, but a mill would be so much easier and cleaner :) Plus the bit doesn't skip across your work. Dremel jumped a couple times and nicked the work. Nothing bad, but will have to work it out on the polishing step. Last edited by Finnster; 11.17.2010 at 12:28 PM.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com