Need a quick Lehner answer...

Originally Posted by Gustav

I said that before we saw the brace.i'd make it smaller,just a simple bar off centre below the bearing would leave more room for the motor wires on the Fiegaos/bks.

I kind of like how it looks right now.. I'll think about it though.. :)

Well, here is the mount assembled for a BK/Feigao motor. Again, the rear brace is move-able for different length motors. None of the screws are shown.. There is still a few details to add, like mounting screw holes on the base and a set screw for the adapter ring for the BK/Feigao motors.

[squeeforever]

its PLENTY big enough. the bearings are only like 8mm.

[mothman]

Im interested in one if you plan on mass producing it.

Since there is some interest, I'm going to make an un-official "testers" list of people interested.. I'm going to limit this list to 3. If there are more than 3 people interested they will be selected by what they are running for RCs ect..

1. mothman
2.
3.
4. ME

This is an un-offical list. You adding your name to the list says that you are prepared to pay the cost for a tester version if I decide to make more than one. I estimate prices to be between $30-40 for testers.. Maybe less, maybe more it will come down to what it costs me.

Also, just an FYI right now I am about 1.5 months away from completing my term at school, so it's basically the most loaded time of the year. I have very little free time, so things like this only happen during my free time.. I may have them done in a week, maybe a month. It will depend on my free time.

Thanks!
AL