Picked up a Stampede 4x4!!

[lincpimp]

Originally Posted by asheck

Sorry, I went with Tekno's so my interest in them has twindled. I will say this, you might want to get started on some front shafts. I totally snapped a stocker off, and I know you have more torque, then mine.

Yeah, you are right. I am thinking some tekno ft hubs, and the bearings are coming that will fit those as well as the rears. Might give the modded lst shafts a try, as the front will see less load than the rears, and I would like to use the pede wheels I have, which means the electric 2wd rears will end up on the front of the 4x4.

I will also be working on a setup for the 2wd pede. I have a big 7th scale 2wd pede based buggy thaty I run a 9l feigao on 3s. It eats driveshafts for lunch.

[J57ltr]

Sorry I wasn't able to get by and drop off the material, I'll send it when I get back. We ran into some major problems on the customers part today and didn't get out of there till 8 tonight. and we are driving back to H'town in the afternoon.

Jeff

[_paralyzed_]

Hey pimple- I'm pretty sure I have a pack of 4 12mm hexes with a set screw. PM me if you want them.

Have you even looked at this? (look) http://www.fastlanemachine.net/prodd...LM26333&cat=31

[lincpimp]

Originally Posted by J57ltr

Sorry I wasn't able to get by and drop off the material, I'll send it when I get back. We ran into some major problems on the customers part today and didn't get out of there till 8 tonight. and we are driving back to H'town in the afternoon.

Jeff

No prob Jeff, I had a rough day as well. Just let me know what I will owe ya for shipping. Had a good time when we were chatting, we will have to catch up someday.

Originally Posted by _paralyzed_

Hey pimple- I'm pretty sure I have a pack of 4 12mm hexes with a set screw. PM me if you want them.

Have you even looked at this? (look) http://www.fastlanemachine.net/prodd...LM26333&cat=31

I did see that, but I did not really have any isses with the axle, I was ripping the inner plastic axle piece that attaches to the diff outputs.

I just picked up a set of the tekno 12mm hexes and some more m6 hubs to play with the front of this truck and the rear of the 2wd pede.

I was just drilling out the srock plastic 12mm hexes. Seemed to work fine.