 |
|
|
|
 |
|
|
 |
 |
|
 |
|
(#1)
|
|
RC-Monster Dual Brushless
Offline
Posts: 4,236
Join Date: Dec 2007
Location: Cape Cod, Mass.
|
04.03.2011, 12:11 PM
Me likey...nicely done. Question though, any reason you did not run esc wire along frame rail to avoid going that close to the pinion gear?
2. MBX-5T 1520, MMM ON 5S 3. MBX-5 ONROAD CONVERSION 1515, MMM ON 5S 4. MRX-3 ON ROAD CONVERSION 1512, MMM ON 6S 5. TEN T 2650 T8, MMP ON 3S |
|
|
|
 |
 |
 |
|
|
|
|
|
|
(#2)
|
|
RC-Monster Aluminum
Offline
Posts: 765
Join Date: Aug 2007
|
04.03.2011, 12:41 PM
It wasn't quite long enough, then an extension would have been too long. It's further away than it looks in the pic and it's not moving so it should be good. I don't even think this thing will see any insane bashing anyway, looks too good IMHO.
|
|
|
|
|
|
|
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Hybrid Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
